Flashing E2

1. First install the 4.5.3 RSDlite

2. make sure the phone in a state of full battery because it requires a lot of power flasing

3. prepare Firmware compatible with your E2 (E2 specific)

 4. E2 right off you, then press the voice button on the top right corner, do not be removed .. then press the power button (red) until the display shows orange color screen, newly released ......
5. click RSDlite is already installed
6. plug the USB cable (data cable E2) from hp to PC
7. if the exit window and found new hardware requires drivers navigate to the folder USB drivers motorola
8. if successful will be out in the list RDSlite
9. titik2 button above, point firmware files
important notes:
if the file flasher / firmware there are 2 files (*. shx and *. SBF), the orange screen after screen, press the voice button (aja cuman coice button) until the second exit orange screen with a different writing .. then the extension *. shx flash .. once the process is completed then the screen will exit the writing RSDlite please manually power blah blah blah ... dislodged the battery and reinsert it, then press the voice and power again ... flash firmware extension *. SBF until the process is complete bring up the message PASS or please manually power blah blah blah ....

if the firmware file cuman if there is one that is files ending in *. SBF, direct flash on the screen orange wrote the first course until the process is complete bring up the message PASS or please manually power blah blah blah ....
10.. completed



Additional:
if you want your E2 will support 4GB flash after flash over again with kernel_4GBSupport.rar which there is a file extension *. SBF in the first orange screen ...


if you want your EDGE always on flash by means of:

1. turn on HP

2. select the menu setting - connection - select the modem

3. start RSDlite

4. E2 plug into your PC

5. RSDlite navigate to the file EDGE Xronos_Scottish7.hs

6. wait until the process of displaying PASS

7. completed